Micro-drop tester for three sample

RJD-WDL-3G-300

The micro drop tester is used to simulate the operator to clamp the cell to be tested together with the clamp according to the required drop direction. The motor lifts the device to the set height and controls the action of the actuator through the program,

Release the clamping mechanism, and the battery will fall to the floor of the specified material in a free falling motion.

In the process of falling, the resistance should be reduced as much as possible, and a wind shield should be added outside the equipment to reduce the influence of indoor air flow on the test. The area where the cell is placed must be insulated to prevent short circuit of the cell.